16
1. SETUP:
A) Set Control Panel Main Switch to
“On”
, this is
shown by the LED
“Panel Power”
when the en-
gine is running.
B) Ensure the agitator is set to the
“Off”
position.
This is the middle position of the spool valve.
2. START ENGINE:
A) Turn key on engine control to
“ 1”
B) Allow 3-5 seconds to heat glow plugs
C) Turn key to
“ 2”
Melter Start Up
Load Material into Empty Tank
All material must be clean. Keep all foreign matter out
of melting tank.
1) Open the material door (a) and place the block of
material (b) on the open door against the holder (c).
2) Push door to the closed position.
TO AVOID CONTACT WITH HOT SEALANT DO NOT
DROP MATERIAL INTO THE MELTER WITH DOOR
OPEN.
LOADING OPERATOR MUST WEAR PROTECTIVE
CLOATHING COVERED ON PAGE 4.
LOAD MATERIAL FROM GROUND ONLY. NEVER
CLIMB ON THE TRAILER TO LOAD.
(a)
(b)
(c)
WARNING
Summary of Contents for ME3
