17
Melter Start Up
3. MELTER PREPERATION
A) Wait for
the two
indicator lights (
GREEN
lights) to
turn on.
B) Turn Agitator to the
“HEAT UP”
position.
4. SETTING AGITATOR SPEED
Wait for material to reach desired temperature
A) Ensure the Agitator is in the “
Heat Up”
position
B) Slowly adjust the Speed Control knob until Agitator is spinning at desired speed.
C) A slower agitator speed is recommended.
DO NOT ROTATE AGITATOR AT GREATER THAN 20 RPM
to ensure proper mixing.
Agitator speed can be observed by looking at the love joy coupling.
Use caution when in proximity to flowing hot material. This
includes proper face and skin protection.
CAUTION
DO NOT OPERATE MACHINE IF DOOR
ACTIVATED AGITATOR STOP IS NOT
WORKING
5. Propane Burner Controls
Needle Valve
(P#: 121163)
Propane Orifice
(P#: 156392)
A) Open Propane Tank and set regulator to 15 PSI.
B) Open ball valves for tool box and heated chute burners on propane system.
C) Slowly open needle valves near propane orifices and light propane burners on heated
chute and heated toolbox.
D) Adjust propane flow on needle valve until desired flame size is reached.
Summary of Contents for ME3
