18
Shut Down Procedure
A) Shut Engine off by turning key to
“0”
B) Set Control Panel Main Panel switch to
“
OFF ”
.
C) Put the Agitator Directional Switch to the
“OFF”
position.
D) Ensure all valves are closed going to the tool box and trough
burners.
Cool Down Procedure
A) Close the 2 propane needle valves (Near the Tool Box Heater and trough), 3 ball
valves (2 at the propane tank and the 3rd at the back of the machine on the
passenger side), and close the propane tank.
B) Set Control Panel Main Panel switch to
“OFF”
. Indicated by the Panel Power
LED being unpowered.
C) Put the agitator into the
“Heat Up”
position.
D) Let machine run for 15 to 30 minutes..
E) Put the Agitator Directional Switch to the
“OFF”
position.
APPLYING MASTIC
With Start Up procedure complete, you are ready to begin sealing
A) Turn Agitator to the
“DISPENSE”
Position
B) Open Material Gate at rear of machine.
C) Let material flow onto heated chute.
D) Scrape material from chute into Desired Tool.
Summary of Contents for ME3
