![background image](http://html.mh-extra.com/html/cinch/opm1730/opm1730_user-manual_2607267007.webp)
12
13
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. (Example- use
only shielded interface cables when connecting to a computer or peripheral devices).
The product does not contain any user-serviceable parts. Unauthorized repairs or modifications could
result in permanent damage to the equipment, and void your warranty and your authority to operate
this device under Part 15 regulations.
CAUTION!
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the users authority to
operate the equipment.
IC Statement
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device. The
device meets the exemption from the routine evaluation limits in section 2.5 of RSS 103 and users
can obtain Canadian information on RF exposure and compliance.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire
de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d’en compromettre le fonctionnement. Le dispositif rencontre
l’exemption des limites courantes d’évaluation dans la section 2.5 de RSS102 et les utilisateurs
peuvent obtenir l’information canadienne sur l’exposition et la conformité de rf.
CE Statement:
Europe – EU Declaration of Conformity This device complies with the essential requirements of
the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove
presumption of conformity with the essential requirements of the R&TTE
Directive 1999/5/EC:
EN 60950-1:2006+A12:2011
EN 55022+EN 55024(2010)
EN 301 489-1 V1.8.1(2008-04)
EN 301 489-3V1.4.1(2002-08)
EN 300 440-2 V1.3.1(2009-03)
This device is a 2.4 GHz wideband transmission system (transceiver), intended for use in all EU
member states and EFTA countries, except in France and Italy where restrictive use applies. In
Italy the end-user should apply for a license at the national spectrum authorities in order to obtain
authorization to use the device for setting up outdoor radio links and/or for supplying public access
to telecommunications and/or network services. This device may not be used for setting up outdoor
radio links in France and in some areas the RF output power may be limited to 10 mW EIRP in the
frequency range of 2454 – 2483.5 MHz. For detailed information the end-user should contact the
national spectrum authority in France. We hereby declare that these products are in compliance with
the essential requirements and other relevant provisions
As a minimum it is recommended to inspect the product for damage including cracks, dents, and
serious scratches after all rides and after transport.
Check that the water tight cap on the non-drive side is fully sealed
Check bolts etc. for correct torque on a regular basis.
Summary of Contents for OPM1730
Page 14: ...B30101 A 50 ...