11
STEP 16: Installing the Dust Bag.
Tie the rope in the grommet at the top of the dust fil-
ter bag
through the two holes in the end of the
horizontal bag support
.
NOTE: Use a temporary knot to hold filter bag in
place.
STEP 17: Installing Dust Bag to Air Flow Diverter.
NOTE: This step is only for dust collectors with a
with a 7
1
⁄
2
horsepower motor. For 3 & 5 horsepow-
er models, go on to STEP 18.
a. Take the third remaining clamp and adjust it to
about 8
1
⁄
2
" diameter.
b. Slide the clamp over the inlet sleeve of the dust
bag .
c. Slide the bag inlet sleeve over the air flow diverter
to within 2" of the screws in Fig. 22.
d. Slide the clamp over the dust bag inlet sleeve and
tighten the clamp.
STEP 18: Installing Dust Bag to Discharge Transition.
NOTE: This step is for 3 & 5 horsepower models.
a. Take the third remaining clamp and adjust it to
about 8
1
⁄
2
" diameter.
b. Slide the clamp over the inlet sleeve of the dust
bag .
c. Slide the bag inlet sleeve over the discharge transi-
tion
➂
so the end of the sleeve is at the transition
seam as shown in Fig. 23.
d. Slide the clamp over the dust bag inlet sleeve and
tighten the clamp.
STEP 19: Installing Dust Bag over drum.
a. Install the large diameter opening of the dust bag
over the lip of a standard 55 gallon steel drum
(not supplied) as shown in Fig. 24.
b. Tighten the dust bag belt clamp to hold the bag
onto the drum.
c. Adjust the rope which was temporarily tied in STEP
16 above so bag does not droop or sag. Retie knot
in rope.
▲
Fig. 21
▲
Fig. 22
▲
Fig.23
▲
Fig.24
12
➅
15
11
12
➂
15
12
12
➂
