Ch 1
Ch 2
Ch 3
Channel 1
ex) Brightne
ss 10 %
Channel 2
ex) Brightne
ss 50 %
Channel 3
ex) Brightne
ss 90 %
After connecting the power adapter and the controller, connect the two lighting bodies and one controller using the two
included RJ45 cables. Connect the power supply to the controller using an adapter, and set the power switch of the controller
to ON, then the power lamp of the controller turns red.
Operating
Operating TL120
Connect LED Panels and controller
Adjusting brightness
Adjust the brightness by turning the dimmer to change left or
right. Turning the dimmer to the right increases the amount of
light, turning the dimmer to the left decreases the amount of light.
When the brightness is 0, the light is not turned on.
Connecting cable to Panel
Connecting cable to Panel & Controller
Power Swith On
