6
Use FuzzyScan in HID Mode
Ensure the battery is fully charged. Power on the scanner within radio
coverage and ensure the status indicator of scanner gives
alternative
red and green blinks
(in “
Uninstall
” state). If your scanner is not in the
Uninstall state, please scan the “
Uninstall
” command first.
Uninstall
If your remote host is equipped with latest Bluetooth drivers, or it’s an iOS
or Android device, it is recommended to use “
HID Mode
”.
HID Mode
Once you had scanned the “
HID Mode
” barcode, the scanner’s link
indicators will blink blue 3 times every 2 seconds during the search
process. You have to execute the Bluetooth Discovery procedure to find
nearby Bluetooth device, then select “F(L/A)xxxBT-xxxx” (the xxxx are the
last 4 digits of its MAC address).
The scanner will emit 4 beeps in ascending tone to indicate the
connection is established. The scanner’s link indicators will also
flash
blue every 2.5 seconds
to indicate a radio-connected state.
If the scanner is not pair with the host device within 1 minute after
scanning the above command, it will enter radio-off state automatically.
You can wake up the scanner by pressing its trigger, this will also cause
the scanner to re-attempt pairing.
The installation procedure may vary depending on different remote
host devices, operating systems and the Bluetooth drivers.
Please
consult your professional IT consultant to obtain necessary support.
