2564MR Barcode Scanner
User Guide
Steps Action
User Feedback if Successful
1
Power on the scanner...
The scanner will respond with a long beep
(high tone) and its LED indicator will
become solid red and go off quickly.
2
Enter the Configuration Mode…
The scanner will respond with six beeps
(high-low tone repeats three times), and its
LED indicator will become flashing red.
3
Read a Setup barcode...
For example,
The scanner will respond with one short
beep if reading a special setup barcode such
as “Prefix Code”, indicating the setup
requires reading more barcodes.
When “BT HID”, “USB HID” or “Keyboard
Wedge” is configured for interface, Key
Type and Key Status will then become
applicable. You may decide whether or not
to change key status when “Normal Key” is
selected for Key Type.
Refer to Appendix III
Read the “Hexadecimal Value” barcodes for
the desired character string. For example,
read “2” and “B” for the scanner to prefix
the character “+”.
Refer to Appendix IV “Hexadecimal
System”
The scanner will respond with two beeps
(low-high tone) when the input values are
validated.
4
Exit the Configuration Mode…
OR
Same as for Enter the Configuration Mode.
5
The scanner will automatically restart itself… Same as for Power on the scanner.
LIST THE CURRENT SETTINGS
Special setup
barcodes
Hexadecimal
barcodes
18
Enter Setup
Summary of Contents for 2564MR
