- 4 -
RK95 Mobile Computer
BATTERY
The main battery may not be charged to full for shipment. Charge the main battery to full
before using the mobile computer for the first time.
Main battery:
The main battery powers the mobile computer to work. It takes
approximately 4 hours to charge an empty
3100mAh
main battery to full while it takes
6 hours to charge an
6200mAh
main battery. For the first time charging the main
battery, please charge it for at least 8 to 12 hours. The charging LED above the screen
will light up in red while charging and will turn green when charging is complete.
When the main battery is removed, RTC retention will be maintained for at least 30
minutes.
Backup battery:
The backup battery is mounted on the main board. Its role is to
temporarily keep the mobile computer in suspension when the main battery is drained
out so data in DRAM will be retained. The backup battery takes approximately 4 hours to
charge to full by the main battery or power adapter.
The allowed battery charging ambient temperature is between 0°C to 45°C. It is
recommended to charge the battery at room temperature (18°C to 25°C) for optimal
performance.
Please note that battery charging stops when ambient temperature drops below 0°C or
exceeds 45°C.
In order to prevent system from shutting down after the battery is drained out, keep a
fresh battery for replacement at all times, or connect the mobile computer to an external
power.
If there are drippings or dust on the device or battery pack, wipe them away with a soft
clean cloth before battery replacement.
Turn off the power before battery replacement.
If you want to put away the mobile computer for a period of time, remove the battery
pack from the mobile computer
’s battery compartment. Store the
mobile computer and
battery pack separately.
Recycle batteries in a proper way for the green-environment issue.
SCANNER
Scan a 1D barcode
1)
Open
ReaderConfig
and tap
Scan Test
on the menu bar.
2)
Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3)
Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed.
Scan a 2D barcode
1)
Open
ReaderConfig
and tap
Scan Test
on the menu bar.
2)
Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3)
Press any of the two side triggers. The scanning light beams to read the printed barcodes.
The buzzer beeps after scanning. The scanning light goes off once the data is decoded,
or when the decode timeout period has passed.