Setup & Configuration
HDE-VoIP Telephones
Page 19
Web Page Item
Description
Enable SIP Operation:
When this option is enabled, the device will initialize the SIP engine
and try to register with a SIP server or listen for incoming SIP
connections.
SIP Transport Protocol
Allows user to select between SIP TCP or UDP mode.
SIP Settings
Register with a SIP Server:
When enabled, the device will attempt to register to the configured
SIP Server(s) on this page. To configure the device to send and
receive point-to-point SIP calls, enable
SIP Operation
and disable
Register with a SIP Server.
Use Cisco SRST:
When enabled, the backup servers are handled according to Cisco
SRST (Survivable Remote Site Telephony). It is required for use in
clustered Cisco Unified Communications Manager topologies.
Use Mitel Resiliency:
When used with MITEL PBX with Mitel proprietary redundancy, this
enables compliance operating mode for compatibility.
Invite Timeout:
When Mitel Resiliency is enabled, the device will use the “Invite
timeout” value for outbound calls. The device will send an invite and
if it does not get a response from the SIP server in <value>
seconds, it will presume the server is down, cancel the call, and
failover to the next server.
Primary SIP Server:
Enter the SIP server address as an IPv4 address in dotted decimal
notation or a fully qualified domain name. This parameter also
becomes the host portion of the SIP-URI for the device's extension
on the primary SIP server. This field can accept entries of up to 255
characters in length.
Primary SIP User ID:
Specify the SIP User ID for the Primary SIP Server. This parameter
becomes the user portion of the SIP-URI for the device's extension
on the primary SIP server. Enter up to 64 alphanumeric characters.
Primary SIP Auth ID:
Specify the Authenticate ID for the Primary SIP Server. This
parameter is required for SIP registration authentication. Enter up to
64 alphanumeric characters.
Primary SIP Auth Password:
Specify the Authenticate Password for the Primary SIP Server. This
parameter is required for SIP registration authentication. Enter up to
64 alphanumeric characters.
Backup SIP Server 1:
Enter the backup SIP server address as an IPv4 address in dotted
decimal notation or a fully qualified domain name. This parameter
also becomes the host portion of the SIP-URI for the device's
extension on the backup SIP server. This field can accept entries of
up to 255 characters in length.
Backup SIP User ID 1:
Specify the SIP User ID for the first backup SIP Server. This
parameter becomes the user portion of the SIP-URI for the device's
extension on the first backup SIP server. Enter up to 64
alphanumeric characters.
Backup SIP Auth ID 1:
Specify the Authenticate ID for the first backup SIP server. This
parameter is required for SIP registration authentication. Enter up to
64 alphanumeric characters.
Backup SIP Auth Password 1:
Specify the Authenticate Password for the first backup SIP server.
This parameter is required for SIP registration authentication. Enter
up to 64 alphanumeric characters.
