– 15 –
10. CAPACITANCE MEASUREMENT
WARNING:
FULLY DISCHARGE THE CAPACITOR BY SHORTING THE CAPACITOR
LEADS TOGETHER BEFORE TESTING.
➔
Set the function switch to 20µ on the
CAPACITANCE
scale.
➔
Insert the capacitor leads into the
jack.
➔
Read the value and unit shown on the display.
If the value does not have enough digits, turn
the function switch to a lower range. Repeat
until you have the maximum digits possible
without displaying ʻIʼ.
➔
If ʻIʼ appears on the display, the value of the
capacitor is over the maximum range of the
meter.
11. HOLD FUNCTION
This function is used to hold a reading. When this
pushbutton is pressed,
the data being displayed at the time will be ʻfrozenʼ in the display and will
appear in the display. Changes in the input signals will not change the display.
This function can be used in all measurement modes. Press the pushbutton
again to release this function and will disappear.
CAP
CIRCUIT-TEST
DMR-4200
20A
TEMP
mA
HOLD
POWER
CAT II 1000V
V/Ω/F/ /
COM
D
C
V
O
LT
S
OHMS
Ω
C
A
PA
C
IT
A
N
CE
AC
V
O
LT
S
AC AMPS
D
C A
M
PS
TEMP F
REQ
CAPACITOR
