Circuit-test DMR-6700, User Manual

- 14 -

Continuity Check

WARNING: 

To avoid electric shock, never measure continuity on circuits 

or wires that have voltage on them.

Resistance Measurements

WARNING: 

To avoid electric shock, disconnect power to the unit under test 

and discharge all capacitors before taking any resistance measurements. 

Remove the batteries and unplug the line cords.

1.   Set the function switch to the 

Ω 

     position.

2.   Insert the black test lead banana plug into the negative 

COM

 jack. Insert the red test lead banana plug into the 

positive 

Ω

 jack.

3.  Press the 

MODE

 button to indicate “

Ω

" on the display.

4.   Touch the test probe tips across the circuit or part under 

test. It is best to disconnect one side of the part under 

test so the rest of the circuit will not interfere with the 

resistance reading.

5.  Read the resistance in the display.

1.   Set the function switch to the 

Ω 

     position.

2.   Insert the black test lead banana plug into the negative 

COM

 jack. Insert the red test lead banana plug into the 

positive 

Ω

 jack.

3.  Press the 

MODE

 button to indicate "   " and "

Ω

" on 

the display.

4.  Touch the test probe tips to the circuit or wire you wish 

to check. 

5.   If the resistance is less than approximately 100Ω, the 

audible signal will sound. If the circuit is open, the display will indicate 

“

OL

”.