- 15 -
NOTE:
The temperature probe is fitted with a type K mini connector. A mini
connector to banana connector adaptor is supplied for connection to the input
banana jacks.
Temperature Measurements
1. Set the function switch to
ºC
or
ºF
position.
2. Insert the Temperature Probe into the input
jacks, making sure to observe the correct
polarity.
3. Touch the Temperature Probe head to the
part whose temperature you wish to measure.
Keep the probe touching the part under test
until the reading stabilizes (about 30 seconds).
4. Read the temperature in the display.
Diode Test
1. Set the function switch to the
Ω
position.
2. Insert the black test lead banana plug into the negative
COM
jack and the red test lead banana plug into the
positive
V
jack.
3. Press the
MODE
button to indicate and
V
on the
display.
4. Touch the test probes to the diode under test. Forward
voltage will typically indicate 0.400 to 0.700V. Reverse
voltage will indicate “
OL
”. Shorted devices will indicate
near 0V and an open device will indicate “
OL
” in both
polarities.
