INSTALLATION
Page 8 of 36
2. INSTALLATION
2.1. MODULE OVERVIEW
The CS-BRT20 Belt Rip and Tear Detector comprises two small sensor enclosures
which are installed on either side of the conveyor belt and one control unit. The sensor
enclosures are wired back to the control unit which can be mounted in a more
accessible location. The control unit houses the primary control unit/board and is the
primary interface for the operator as well as to the control system (hardwired and
communications). This configuration allows for individual components to be easily
replaced should they become damaged.
Figure 2.1
–
Receiver and Emitter Enclosures
Figure 2.2
–
Main Control Enclosures (closed and open)