airREPEATER
Pag 8 of 9
Instructions manual
9
LED/PUSH-BUTTON INTERFACE
The Repeater has three LED through which it is possible to obtain information on the device's operating
state. Furthermore, the Repeater has a push-button which makes it possible to send commands to the
device.
Behaviour of LED indicators at the start-up:
At the reset of the Repeater all LED indicators light for 2 seconds, then all flash fast for another 2
seconds and after the flashing the device starts the normal operation.
How do the LED
indicators work when the Repeater is NOT ASSOCIATED to a network:
If the Repeater is not associated to a network, all LED light steady with a short flash every 20 seconds.
How do the LED
indicators work when the Repeater is ASSOCIATED TO A NETWORK:
LD1 (yellow) : Working Status
Slow flashing (1Hz)
-> Router LINKED (Closed)
Fast flashing (4Hz)
-> Router NOT LINKED (Open)
LD2 (middle led, green): Radio Link
Turned off
-> No Router with good link in the proximity
1 flash + pause
-> One Router with good link in the proximity
2 f pause -> Two Routers with good link in the proximity
3 f pause -> Four or more Routers with good link in the proximity
LD3 (bottom LED, green): Radio Activity
Usually turned off
Short Flash on transmitting or receiving a radio message