• Near steam and/or condensation
• Where the system could be exposed to engine exhaust
Note: Storing your Cirrus R/C system under the conditions outlined above can result in deteriation/
deformation of the casing and damage to the electronics.
Receiver, Servo and Speed Controller Connection
Note: Use base illustrations as created for the 2CAM instructions, although these will need to be
modified slightly to show 3rd channel servo.
Connections for installation in an
Connections for installation in an
electric powered model.
engine powered model.
Assembly Precautions
Important
• Periodically check the receiver, servos and battery connectors to be sure that all are firmly joined. If a connector
is not fully inserted, vibration can cause it to work loose while your model is operating, resulting in a loss of
control.
• The receiver aerial may seem overlong, but its length is critical -
DO NOT
cut it. If the length of the receiver
aerial is altered, the receiver will be adversely affected, resulting in reduced range and/or loss of control.
• Ensure that the receiver is mounted at least 13mm (1/2 inch) away from any devices that give off high frequency
noise; motors, batteries and wiring that can handle high current loads. High frequency noise will cause a
reduction in operating range and can cause loss of control.
(CH3)
Possible Reverse Gear/
Other Purpose
(CH2)
(CH1)
12
