C I R R U S
C O M P O N E N T M A I N T E N A N C E M A N U A L - C A P S
M O D E L S R 2 0
95-01-01
Page 25
All
EFFECTIVITY:
Figure 95-01-017
Empennage Cover Replacement (1 of 2)
3.25 inches
(8.26 cm)
9.5 inches
(24.1 cm)
FUSELAGE
(REF)
REAR WINDOW
(REF)
SR20_CM95_2970
LEGEND
1. CAPS Cover
NOTE
1
1
ANVIL
(REF)
SLIDE HAMMER
(REF)
Reinforced cover section.
At pilot hole, use 5/8 inch drill bit with stop collar to drill hole that facilitates
insertion of slide hammer fitting.
CAPS cover remnant may be used as an outline template to facilitate
cover installation. Avoid unnecessary damage to remnant cover during removal.
WARNING
Use utmost care when working around embedded forward harness straps and
lightning protection mesh with sharp tools. Failure to follow this WARNING
could result in damage to CAPS system and failure upon deployment.
01 Feb 2013