Cirrus Design
Section 4
SR22T
Normal Procedures
P/N 13772-005
4-5
P/N 13772-005
4-5
c. Bat 2 Master Switch ...........................................................ON
d. PFD ........................................................................... Verify On
e. Essential Bus Voltage............................................. 23-25 Volts
f.
Flap Position Light ........................................................... OUT
g. Bat 1 Master Switch ............................................................ON
h. Avionics Cooling Fan .................................................... Audible
i.
Oxygen Masks/Cannulas and Hoses .............Check Condition
j.
Oxygen System ...................................................................ON
(1) Quantity........Verify adequate supply for flight with reserve
(2) Flow ................................... Check flowmeter on all masks
(3) Oxygen System...........................................................OFF
k. Lights............................................................. Check Operation
l.
Stall Warning .....................................................................Test
• Note •
Test stall warning system by applying suction to the stall
warning system inlet and noting the warning horn sounds.
m. Fuel Quantity ................................................................. Check
n. Fuel Selector .............................................. Select Fullest Tank
o. Flaps.....................................................100%, Check Light ON
p. Bat 1 and 2 Master Switches.............................................OFF
q. Circuit Breakers.................................................................... IN
r.
Fire Extinguisher ................................. Charged and Available
s. Emergency Egress Hammer ......................................Available
t.
CAPS Handle .....................................................Pin Removed
2. Left Fuselage
a. Door Lock ...................................................................... Unlock
b. COM 1 Antenna (top) ......................Condition and Attachment
c. Transponder Antenna (underside)...Condition and Attachment
d. Wing/Fuselage Fairing.................................................... Check
e. COM 2 Antenna (underside) ...........Condition and Attachment
(Continued on following page)
Original Issue