VCC-SXCXP3M Rev. 905-0049-00
©2017 CIS Corporation. All rights reserved.
22
9.4 Burst Mode
The start and stop of sequence operation can be controlled by the edge control or level control of trigger input signals,
and register start.
・
S
et TriggerSelectorAndActivation to FrameBurstStart.
(1). Edge Control
TRIG IN
Video Out
Effective Line
Exposure
Effective Line
①
FVAL Out
②
Sequence Control Start
Sequence Control Finish
Effective Line
Effective Line
Effective Line
①
・
S
et SequencerActivation to FrameBurstStartEdge to start sequence operation by inputting a trigger.
・
Exposure time (
①
) and output frame time (
②
) for each frame shall be controlled by the preset sequence parameter
set and link configuration settings.
・
When the image output for the sequence Loop count is completed, sequence operation ends.
(2). High Level Control
TRIG IN
Video Out
Effective Line
Exposure
Effective Line
①
FVAL Out
②
Sequence Control Start
Sequence Control Finish
Sequence Control Stop
Sequence Control ReStart
Effective Line
Effective Line
Effective Line
①
・
S
et SequencerActivation to FrameBurstStartLevel to start sequence operation while trigger input is at high level.
・
Sequence operation can be paused by changing the trigger input to Low level. If you wish to end Sequence
operation, turn OFF sequence control.
・
By changing the trigger input to High level, Sequence operation can be resumed.
・
When the image output for the sequence Loop count is completed, sequence operation ends.
(3). Resister Start
・
Sequence operation starts at the same time when SequencerActivation is turned off and FrameBurstStartSoftware is
set.
※
To restart burst mode operation, turn off SequencerActivation OFF once.
