VCC-G22U21ACL
Rev.900-612-32-00
©2009 CIS Corporation. All rights reserved.
3
1. Scope of Application
This is to describe VCC-G22U21ACL Power Over Camera Link B/W CCD Camera. All specifications contained
herein are subject to change without prior notice. Reproduction in whole or in part is prohibited.
2. Handling Precautions
The camera must not be used for any nuclear equipments or aerospace equipments with which mechanical
failure or malfunction could result in serious bodily injury or loss of human life. Our warranty does not apply to
damages or defects caused by irregular and/or abnormal use of the product.
Please observe all warnings and cautions stated below.
Our warranty does not apply to damages or malfunctions caused by neglecting these precautions.
z
Do not use
or store
the camera in the following extreme conditions:
¾
Extremely dusty or humid places.
¾
Extremely hot or cold places (operating temperature –5 to +45 )
℃
℃
¾
Close to generators of powerful electromagnetic radiation such as radio or TV transmitters.
¾
Places subject to fluorescent light reflections.
¾
Places subject to unstable (flickering, etc.) lighting conditions.
¾
Places subject to strong vibration.
z
Remove dust or dirt on the surface of the lens with a blower.
z
Do not apply excessive force or static electricity that could damage the camera.
z
Do not shoot direct images that are extremely bright (e.g., light source, sun, etc.), and when camera
is not in use, put the lens cap on.
z
Follow the instructions in Chapter 6, “External connector pin assignment” for connecting the camera.
Improper connection may cause damages not only to the camera but also to the connected devices.
z
Confirm the mutual ground potential carefully and then connect the camera to monitors or computers.
AC leaks from the connected devices may cause damages or destroy the camera.
z
Do not apply excessive voltage. (Use only the specified voltage.) Unstable or improper power supply
voltage may cause damages or malfunction of the camera.
