16
INSTALLING THE BUTTON
The
BUTTON
is an accessory which must be applied to the panel on the inside of the
door. The anchor fixing system is ideal for panels with a maximum thickness of 10
mm.
•
Make a 50 mm diameter hole in the panel, respecting the tolerances indicated in
the drawing (Fig. 1).
•
Connect the BLE C5 cable (previously connected to the lock) to the
BUTTON
.
•
Place the
BUTTON
support inside the hole, following the instructions on the sticker
on the
BUTTON
.
•
Screw in the two fixing screws until the anchors are tight against the surface of the
panel.
•
Apply the aluminium protective rose, taking care to position the groove to remove it
at the bottom (if applying the round version, position the groove at the bottom and
turn it slightly to the right or left to ensure the protective rose is securely fitted).
Fig. 1
50 +/- 0,2 mm
C5
