Please note that the serial number is located on the product label at the bottom panel of the GX50.
Mounting Hardware
The supplied wall screws and anchors allow you to mount the appliance on a drywall surface, either vertically or horizontally. The distance between the holes
you drill should be 5-1/8 inches (13 cm).
• For mounting on drywall, use a ¼-in drill bit, then insert the plastic and screw assemblies.
• For mounting on wood or a similar surface, use only the screws.
• Allow the heads of the screws to stick out far enough to be inserted securely into the back of the appliance.
Connecting to WAN
All Meraki Go GX devices must have an IP address. This section describes how to configure your local area network before you deploy it. A local management
web service, running on the appliance, is accessed through a browser running on a client PC. This web service is used for configuring and monitoring basic ISP/
WAN connectivity.
Setting up a Static IP Address
Computers tend to avoid connections without working internet. Disabling other network connections helps make sure this step works.
To ensure that the client PC is redirected to the local web service in the following step, you must disable all other network services (eg: wi-fi) on your
client machine.
3
