5-12
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 5 Distributing Bandwidth Between Queues
Bandwidth Distribution Between Queues
Verifying and Monitoring Bandwidth Distribution
The Cisco 10000 series router collects statistical information about the current queue length, and the
number of packets and bytes transmitted and dropped (64 bits), which you can display using the
show
commands in this section.
To verify and monitor bandwidth distribution in a policy map, enter the following commands in
privileged EXEC mode:
Command
Purpose
Router#
show policy-map interface
Displays the configuration of all classes configured for all policy
maps attached to all interfaces.
Router#
show policy-map interface
interface
[
input
|
output
]
Displays the configuration of all classes configured for all inbound
or outbound policy maps attached to the specified interface.
interface
is the name of the interface or subinterface whose policy
configuration you want to display.
input
indicates to display the statistics for the attached inbound
policy.
output
indicates to display the statistics for the attached outbound
policy.
Note
If you do not specify
input
or
output
, the router displays
information about all classes that are configured for all
inbound and outbound policies attached to the interface
you specified.
Router#
show policy-map
policy-map-name
Displays the configuration of all classes contained in the policy
map you specify.
policy-map-name
is the name of the policy map whose
configuration information you want to display. The name can be a
maximum of 40 characters.
If you do not specify a
policy-map-name
, the command displays
the configuration of all policy maps configured on the router.
Router#
show policy-map
policy-map-name
class
class-name
Displays the configuration of the class you specify. The policy
map you specify includes this class.
policy-map-name
is the name of the policy map that contains the
class configuration you want to display.
class-name
is the name of the class whose configuration you want
to display. If you do not specify
class-name
, the router displays
class configuration for all classes in the policy map.