16-6
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 16 Fragmenting and Interleaving Real-Time and Nonreal-Time Packets
Link Fragmentation and Interleaving
•
Multi-VC MLP over ATM-based LFI
–
1 to 9999 (Cisco IOS Release 12.2(28)SB and later releases)
–
1 to 9999 and 65,536 to 2,147,483,647 (Cisco IOS Release 12.2(31)SB2 and later releases)
•
MLP over Frame Relay-based LFI
–
10,000 and higher
For releases prior to Cisco IOS Release 12.2(28)SB,
the
valid multilink interface range is 1 to
2,147,483,647.
ppp multilink Command
To enable Multilink PPP (MLP) on an interface, use the
ppp multilink
command in interface
configuration mode. To disable MLP, use the
no
form of the command. By default, the command is
disabled.
ppp multilink
no ppp multilink
ppp multilink Command History
Usage Guidelines for the ppp multilink Command
The
ppp multilink
command applies only to interfaces that use Point-to-Point Protocol (PPP)
encapsulation.
When you use the
ppp multilink
command, the first channel negotiates the appropriate Network Control
Protocol (NCP) layers (such as the IP Control Protocol and IPX Control Protocol), but subsequent links
negotiate only the Link Control Protocol (LCP) and MLP.
Cisco IOS Release
Description
Release 12.0(23)SX
The
ppp multilink
command was introduced on the PRE1.
Release 12.2(16)BX
This command was introduced on the PRE2.
Release 12.2(28)SB
This command was integrated in Cisco IOS Release 12.2(28)SB for the
PRE2.
Release 12.2(31)SB2
This command was introduced on the PRE3.
