17-38
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Shaping PPPoE Over VLAN Sessions Using RADIUS
Step 3
(cont.)
Router(config-pmap-c)#
bandwidth
{
bandwidth-kbps
|
percent
percentage
|
remaining percent
percentage
}
account
{{{
qinq
|
dot1q
}
{
aal5
|
aal3
}
{
subscriber-encapsulation
}}
|
{
user-defined
offset
[
atm
]}}
aal3
specifies the ATM Adaptation Layer 5 that supports both
connectionless and connection-oriented links. You must specify
either
aal3
or
aal5
.
subscriber-encapsulation
specifies the encapsulation type at the
subscriber line.
user-defined
indicates that the router is to use the
offset
you
specify when calculating ATM overhead.
offset
specifies the offset size the router is to use when calculating
ATM overhead. Valid values are from -63 to 63 bytes.
Note
The router configures the offset size if you do not specify
the
offset
option.
atm
applies ATM cell tax in the ATM overhead calculation.
Note
Configuring both the
offset
and
atm
options adjusts the
packet size to the offset size and then adds ATM cell tax.
Step 4
Router(config-pmap-c)#
exit
Exits policy-map class configuration mode.
Step 5
Router(config-pmap)#
policy-map
policy-map-name
Creates or modifies the parent policy.
policy-map-name
is the name of the parent policy map. The name
can be a maximum of 40 alphanumeric characters.
Step 6
Router(config-pmap)#
class
class-default
Configures or modifies the parent class-default class.
Note
You can configure only the class-default class in a parent
policy. Do not configure any other traffic class.
Command
Purpose