17-42
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 17 Configuring Dynamic Subscriber Services
Shaping PPPoE Over VLAN Sessions Using RADIUS
Verifying Per Session Queuing and Shaping Policies
To display the configuration of per session queuing and shaping policies for PPPoE over VLAN, enter
any of the following commands in privileged EXEC mode:
Verification Examples for Per Session Queuing and Shaping Policies
Example 17-25
shows sample output for the
show policy-map interface
command. In the example,
overhead accounting is enabled for both shaping and bandwidth.
Example 17-25 Sample Output for the show policy-map interface Command
Router#
show policy-map interface virtual-access 1
!
!
Service-policy output: TEST
Class-map: class-default (match-any)
100 packets, 1000 bytes
30 second offered rate 800 bps, drop rate 0 bps
Match: any
shape (average) cir 154400, bc 7720, be 7720
target shape rate 154400
overhead accounting: enabled
bandwidth 30% (463 kbps)
overhead accounting: disabled
queue limit 64 packets
(queue depth/total drops/no-buffer drops) 0/0/0
(pkts output/bytes output) 100/1000
Command
Purpose
Router#
show policy-map interface
interface
Displays information about the policy map attached to the
interface you specify. If you do not specify an interface, it
displays information about all of the policy maps configured on
the router.
interface
specifies the virtual-access interface and number the
router created for the session (for example, virtual-access 1).
Router#
show policy-map session uid
uid-number
Displays the session QoS counters for the subscriber session you
specify.
uid
uid-number
defines a unique session ID. Valid values for
uid-number
are from 1 to 65535.
Router#
show running-config
Displays the running configuration on the router. The output
shows the AAA setup and the configuration of the policy map,
ATM VC, PPPoA, dynamic bandwidth selection, virtual
template, and RADIUS server.