1-32
Cisco 10000 Series Router Quality of Service Configuration Guide
OL-7433-09
Chapter 1 Quality of Service Overview
QoS Features, Commands, and Changes
Cisco IOS Release:
Release 12.2
Description:
This command was changed to
ppp multilink group
on the PRE2 to restrict a physical
link to joining only a designated multilink group interface. The multilink-group command is accepted
by the command line interpreter through Cisco IOS Release 12.2.
Cisco IOS Release:
Release 12.2(28)SB
Description:
This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release:
Release 12.2(31)SB2
Description:
This command was introduced on the PRE3.
ppp multilink Command
Cisco IOS Release:
Release 12.0(23)SX
Description:
The
ppp multilink
command was introduced on the PRE1 to enable Multilink PPP (MLP)
on an interface.
Cisco IOS Release:
Release 12.2(16)BX
Description:
This command was introduced on the PRE2.
Cisco IOS Release:
Release 12.2(28)SB
Description:
This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release:
Release 12.2(31)SB2
Description:
This command was introduced on the PRE3.
ppp multilink fragment-delay Command
Cisco IOS Release:
Release 12.0(23)SX
Description:
The
ppp multilink fragment-delay
command was introduced on the PRE1 to specify the
maximum amount of time, in milliseconds, that is required to transmit a fragment.
Cisco IOS Release:
Release 12.2(16)BX
Description:
This command was introduced on the PRE2.
Cisco IOS Release:
Release 12.2(28)SB
Description:
This command was integrated in Cisco IOS Release 12.2(28)SB.
Cisco IOS Release:
Release 12.2(31)SB2
Description:
This command was introduced on the PRE3.