0/2
C1111-LTE
ok
00:02:41
0/3
ISR-AP1100AC-N
ok
00:02:41
R0
C1111-8PLTELAWN
ok, active
00:04:56
F0
C1111-8PLTELAWN
ok, active
00:04:56
P0
PWR-12V
ok
00:04:30
Slot
CPLD Version
Firmware Version
--------- ------------------- ---------------------------------------
0
17100501
16.6(1r)RC3
R0
17100501
16.6(1r)RC3
F0
17100501
16.6(1r)RC3
Commonly Used ROM Monitor Commands
This table summarizes the commands commonly used in ROM Monitor. For specific instructions on using
these commands, refer to the relevant procedure in this document.
Table 9: Commonly Used ROM Monitor Commands
Description
ROMMON Command
Manually boots a Cisco IOS XE software image.
boot image
Changes the config-register setting.
confreg
Displays the available local storage devices.
dev
Displays the files on a storage device.
dir
Resets the node.
reset
Displays the currently set ROM Monitor
environmental settings.
set
Saves the new ROM Monitor environmental settings.
sync
Removes an environmental variable setting.
unset
Displaying the Available ROM Monitor Commands
This topic describes the available
help
commands for ROM Monitor mode.
Table 10: Help Commands in ROMMON
Description
Command
Displays a summary of all available ROM Monitor
commands.
help
or
?
Displays information about command syntax.
-?
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
43
ROM Monitor Overview and Basic Procedures
Entering ROM Monitor Mode