Entering Environment Variable Settings
Environment variable settings are entered in capital letters, followed by a definition. The following example
shows the environmental variables used to configure the control Ethernet port on a router:
rommon >
IP_ADDRESS=10.0.0.2
Saving Environment Variable Settings
To save the current environment variable settings, enter the
sync
command:
rommon >
sync
Environmental values that are not saved with the
sync
command are discarded whenever the system is
reset or booted.
Note
Exiting ROM Monitor Mode
To exit ROM Monitor mode, you must change the configuration register and reset the router.
SUMMARY STEPS
1.
confreg
2.
Respond to each prompt as instructed.
3.
reset
DETAILED STEPS
Purpose
Command or Action
Initiates the configuration register configuration prompts.
confreg
Example:
rommon 1> confreg
Step 1
See the example that follows this procedure for more
information.
Respond to each prompt as instructed.
Step 2
Resets and initializes the router.
reset
Example:
rommon 2> reset
Step 3
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
46
ROM Monitor Overview and Basic Procedures
Exiting ROM Monitor Mode
