Preface
Related Documentation
xii
Cisco 1760 Modular Access Router Hardware Installation Guide
78-13342-03
•
Chapter 3, “Troubleshooting,”
describes some problems that you might have
with the router and how to solve these problems.
•
Appendix A, “Technical Specifications,”
lists the physical characteristics,
environmental requirements, and power specifications for the router.
•
Appendix B, “Cabling Specifications,”
describes the cables and cabling
guidelines for the router.
•
Appendix C, “Installing and Upgrading Memory and Packet Voice Data
Modules,”
describes how to install or upgrade memory or data modules in
your router.
•
Appendix D, “Installing the Virtual Private Network Module,”
describes how
to install the Virtual Private Network (VPN) module in the router.
•
Appendix E, “Installing the Echo Canceler Expansion Modules on Cisco
Interface Cards,”
provides information about the echo canceler expansion
modules that are available for use on the 1-port RJ-48 T1/E1 multiflex trunk
(VWIC2-1MFT-T1/E1), and on the 2-port RJ-48 T1/E1 multiflex trunk
(VWIC2-2MFT-T1/E1) interface cards.
Related Documentation
The following publications provide related information on this product:
•
Quick Start Guide for Installing Your Cisco 1760 Modular Access Router,
which came with your router, explains how to install voice hardware and how
to configure the router for a Voice-over-IP (VoIP) network.
•
Cisco 1700 Router Software Configuration Guide
describes some common
network scenarios and how to use the Cisco IOS command-line interface
(CLI) to configure the router in these scenarios.
•
Cisco 1751 Router Software Configuration Guide
provides instructions on
how to use Cisco IOS software to configure voice interfaces and virtual LANs
(VLANs). The configuration information in this document also applies to the
Cisco 1760 router.
•
Cisco 1- and 2-port T1/E1 Multiflex Voice/WAN Interface Cards for the Cisco
1751 and 1760 Routers
provides information about the Cisco 1-port and the
Cisco 2-port multiflex trunk interface cards.
