D-9
Cisco 1760 Modular Access Router Hardware Installation Guide
78-13342-03
Appendix D Installing the Virtual Private Network Module
Installing the VPN Module in a Cisco 1760 Router
Closing the Cisco 1760 Chassis
After installing the VPN module on the motherboard, close the chassis by
following these steps:
Step 1
Slide the top cover of the router back on the bottom of the chassis by pushing it
in the opposite direction from that shown in
Figure D-2
, “
Removing the Top
Cover of the Router
,” on page D-5.
Step 2
Replace the screws that you removed when you opened the chassis. (See
Figure D-1
, “
Removing the Cisco 1760 Chassis Screws
,” on page D-5.)
