Chapter 2 Installation
Connecting the Router to Your Local Network
2-6
Cisco 1760 Modular Access Router Hardware Installation Guide
78-13342-03
Figure 2-4
Attaching the Cable Guide to the Router
Connecting the Router to Your Local Network
The router is connected to your local Ethernet network through the yellow 10/100
Ethernet port. You must provide the following items for this connection:
•
A straight-through, RJ-45-to-RJ-45 Ethernet cable
•
A 10/100-Mbps Ethernet hub or switch
Warning
The ports labeled
10/100-Mbps Ethernet port
and
Console port
are safety
extra-low voltage (SELV) circuits. SELV circuits should only be connected to
other SELV circuits. Because BRI circuits are treated like telephone-network
voltage, avoid connecting the SELV circuits to the telephone network voltage
(TNV) circuits. (To see translated versions of this warning, refer to the
Regulatory Compliance and Safety Information for Cisco 1700 Routers
document
that came with the router.)
Caution
Always connect the Ethernet cable to the yellow ports on the router. Do not
connect the cable to an ISDN S/T or U port on a WIC or to an NT1 that is
connected to a WIC. Accidentally connecting the cable to the wrong port can
damage your router.
Cisco 1700
Series
10/100 ETHE
RNET
AUX
CONSOLE
PVDM 0
OK
OK
PWR
1
0
SLOT 0
OK
PVDM 1
OK
MOD
OK
1
0
SLOT 1
OK
LINK
100
FDX
ACT
COL
1
0
SLOT 2
OK
1
0
SLOT 3
OK
65286
Cable guide screw
