13-11
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 13 Configuring Hybrid REAPWireless Device Access
Configuring Hybrid REAP
Using the CLI to Configure the Controller for Hybrid REAP
Use these commands to configure the controller for hybrid REAP:
•
config wlan h-reap local-switching
wlan_id
enable
—Configures the WLAN for local switching.
Note
When you enable hybrid-REAP local switching, the controller waits to learn the client IP
address by default. However, if the client is configured with Fortress Layer 2 encryption, the
controller cannot learn the client IP address, and the controller periodically drops the client.
Use this command to disable the client IP address learning feature so that the controller
maintains the client connection without waiting to learn the client IP address:
config wlan
h-reap learn-ipaddr
wlan_id
disable
. The ability to disable this feature is supported only
with hybrid-REAP local switching; it is not supported with hybrid-REAP central switching.
If you later want to re-enable this feature, enter this command:
config wlan h-reap
learn-ipaddr
wlan_id
enable
.
•
config wlan h-reap local-switching
wlan_id
disable
—Configures the WLAN for central
switching. This is the default value.
Note
Go to the
“Configuring an Access Point for Hybrid REAP” section on page 13-11
to configure up to six
access points for hybrid REAP.
Use these commands to obtain hybrid-REAP information:
•
show ap config general
Cisco_AP
—Shows VLAN configurations.
•
show wlan wlan_id
—Shows whether the WLAN is locally or centrally switched.
•
show client detail
client_mac
—Shows whether the client is locally or centrally switched.
Use these commands to obtain debug information:
•
debug hreap aaa
{
event
|
error
} {
enable
|
disable
}—Enables or disables debugging of
hybrid-REAP backup RADIUS server events or errors.
•
debug hreap cckm
{
enable
|
disable
}—Enables or disables debugging of hybrid-REAP CCKM.
•
debug hreap group
{
enable
|
disable
}—Enables or disables debugging of hybrid-REAP groups.
•
debug pem state
{
enable
|
disable
}—Enables or disables debugging of the policy manager state
machine.
•
debug pem events
{
enable
|
disable
}—Enables or disables debugging of policy manager events.
Configuring an Access Point for Hybrid REAP
This section provides instructions for configuring an access point for hybrid REAP using either the
controller GUI or CLI.
Using the GUI to Configure an Access Point for Hybrid REAP
Follow these steps to configure an access point for hybrid REAP using the controller GUI.
Step 1
Make sure that the access point has been physically added to your network.
