4021196 Rev A
81
Manage the Gateway
Administration > Diagnostics
Administration diagnostics allow you to check the status of your Internet connection
by using a Ping test.
Select the
Diagnostics
tab to open the Administration Diagnostics page.
Use the descriptions and instructions in the following table to configure the
diagnostics feature on the gateway. After you make your selections, click
Save
Settings
to apply your changes or
Cancel Changes
to cancel.
Section
Field Description
Ping Test
Ping Test Parameters
Ping Target IP
The IP address that you want to ping
Ping Size
The size of the packet you want to use
Number of Pings
The number of times you wish to ping the target device
Ping Interval
The time period (milliseconds) between each ping
Ping Timeout
The desired time period (milliseconds) of the timeout. If no
response is received within this ping period, the ping test is
considered a failure
Start Test
To start a test, complete the following steps.
1
Click
Start Test
to begin the text. A new page opens and
displays a summary of the test results.
2
Click the
Save Settings
to save the test results or click
Cancel Changes
to cancel the test.
