C H A P T E R
2-1
Cisco AS5400 Universal Gateway Chassis Installation Guide
OL-2847-02 0A
2
Preparing to Install
This chapter describes the tasks you must perform before you begin to install the universal gateway and
includes the following sections:
•
Safety Recommendations, page 2-1
•
Required Tools and Equipment, page 2-3
•
Preparing to Connect to a Network, page 2-3
Note
Unless specifically noted, all references to the Cisco AS5400 also apply to the
Cisco AS5400HPX.
Safety Recommendations
Any device that uses electricity must be handled carefully; follow these guidelines to ensure general
safety:
•
Keep the chassis area clear and dust-free during and after installation.
•
Put the removed chassis cover in a safe place.
•
Keep tools away from walk areas where you and others could fall over them.
•
Do not wear loose clothing that could get caught in the chassis. Fasten your tie or scarf and roll up
your sleeves.
•
Wear safety glasses if you are working under any conditions that might be hazardous to your eyes.
•
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
Warning
Ultimate disposal of this product should be handled according to all national laws and
regulations. To see translations of the warnings that appear in the publication, refer to
the
Regulatory Compliance and Safety Information
document that accompanied this
device.
