3-4
Cisco AS5400 Universal Gateway Chassis Installation Guide
OL-2847-02 0A
Chapter 3 Installing the Cisco AS5400 and Cisco AS5400HPX Universal Gateways
Setting Up the Chassis
Warning
Before working on a chassis or working near power supplies, unplug the power cord on
AC units; disconnect the power at the circuit breaker on DC units. To see translations of
the warnings that appear in the publication, refer to the
Regulatory Compliance and
Safety Information
document that accompanied this device.
Required Tools and Equipment
You need the following tools and equipment to rack-mount the chassis:
•
Number 2 Phillips screwdriver (not included)
•
Screws for attaching the chassis to the rack (not included)
•
Standard rack-mount brackets (included)
Figure 3-2
Standard Rack-Mount Brackets
Installing in a Rack
Step 1
To install the chassis in a rack, attach the brackets as follows:
•
With the standard brackets on the side panels of the universal gateway and the front panel forward
or rear panel forward, as shown in
Figure 3-3
and
Figure 3-4
.
Figure 3-3
Standard Bracket Installation—Front Panel Forward
H6028
Bracket for 23- or 24-inch rack
Bracket for 19-inch rack
H10643
