C-1
Cisco AS5400 Universal Gateway Chassis Installation Guide
OL-2847-02 0A
A P P E N D I X
C
Cabling Specifications
This appendix provides the following cabling and pinout information for the Cisco AS5400 and
Cisco AS5400HPX universal gateways:
•
Console and Auxiliary Port Cables and Pinouts, page C-1
•
Ethernet Port Pinouts, page C-4
•
BITS Cable and Port Pinouts, page C-5
•
Alarm Port Pinouts, page C-5
•
Bantam Jack Port Pinouts, page C-6
Note
This appendix specifies pinouts only for the pins used. Pins not listed in the tables in this
appendix are not connected.
Note
Unless specifically noted, all references to the Cisco AS5400 also apply to the
Cisco AS5400HPX.
Console and Auxiliary Port Cables and Pinouts
The universal gateway arrives with a console and auxiliary cable kit, which contains the cable and
adapters you need to connect a console (an ASCII terminal or PC running terminal emulation software)
or modem to your universal gateway. The console and auxiliary cable kit includes:
•
RJ-45-to-RJ-45 rollover cable. (See the next section, “
Identifying a Rollover Cable
,” for more
information.)
•
RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL).
•
RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL).
•
RJ-45-to-DB-25 male DCE adapter (labeled MODEM).
For console connections, proceed to the section “
Console Port Cables and Pinouts
” on page C-2. For
modem connections, proceed to the section “
Auxiliary Port Signals and Pinouts
” on page C-4.
