Chapter 2 Installing the SN 5428 Storage Router
Installing the SN 5428 Chassis
2-6
Cisco SN 5428 Storage Router Hardware Installation Guide
OL-4796-01
Installing the SN 5428 Chassis
You can install the SN 5428 chassis on a table or a shelf, or in an equipment rack.
The following sections describe the steps required to install the SN 5428 chassis:
•
Installing on a Table or a Shelf, page 2-6
•
Rack-Mounting the SN 5428 Storage Router, page 2-7
•
Attaching the Optional Cable Guide, page 2-10
Before installing the storage router, read the Site Preparation and Safety Guide to
familiarize yourself with proper site and environmental conditions.
Installing on a Table or a Shelf
You can install the SN 5428 Storage Router chassis on a table or a shelf (or
another flat, secure surface).
If you are going to install the SN 5428 Storage Router in an equipment rack, skip
this section and proceed to the
“Rack-Mounting the SN 5428 Storage Router”
section on page 2-7
. To install the chassis on a table or a shelf, follow these steps:
Step 1
Locate the four adhesive-backed rubber feet. They are in the accessory kit that is
shipped with the storage router.
Step 2
Peel the rubber feet from their backing and place the feet, adhesive-side down,
onto the four round recessed areas on the bottom of the chassis.
Step 3
Place the storage router on a table or a shelf near an AC power source.
