Chapter 2 Installing the SN 5428 Storage Router
Connecting to Gigabit Ethernet and Fibre Channel Ports
2-20
Cisco SN 5428 Storage Router Hardware Installation Guide
OL-4796-01
Figure 2-16 Removing a Bale Clasp SFP Module with a Flat-Blade Screwdriver
Connecting to Gigabit Ethernet and Fibre Channel
Ports
The Gigabit Ethernet ports, GE 1 and GE 2, use MT-RJ-type or LC-type
fiber-optic SFP modules and cables. The Fibre Channel ports, FC 1 though FC 8,
use LC-type fiber-optic SFP modules and cables. When you are connecting a
cable to a fiber-optic SFP module, make sure that you firmly press the cable plug
into the socket. The upper edge of the plug must snap into the upper front edge of
the socket. You should hear the plug click when it is locked into the socket. To
make sure that the plug is locked into the socket, gently pull on it.
To disconnect a plug from a socket, press the trigger on top of the plug, releasing
the latch. You should hear a click, which indicates that the latch has released.
Carefully pull the plug out of the socket.
73998
