10
Cisco 550X Series Stackable Managed Switches Quick Start Guide
•
115200 bits per second
•
8 data bits
•
no parity
•
1 stop bit
•
no flow control
S
TEP
4
Enter a username and password. The default username is
cisco
,
and the default password is
cisco
. Usernames and passwords are
both case sensitive.
If this is the first time that you have logged on with the default
username and password, the following message appears:
Please change your password from the default
settings. Please change the password for better
protection of your network. Do you want to change
the password (Y/N) [
Y
]?
S
TEP
5
Enter
Y
, and set a new administrator password.
N
OTE
Password complexity is enabled by default. The password
must comply with the default complexity rules.
C
AUTION
Make sure that any configuration changes made are saved
before exiting.
You are now ready to configure the switch. Refer to the
Cisco
550X Series Stackable Managed Switches Command Line
Interface Reference Guide
for further information.
N
OTE
If you are not using DHCP on your network, set the IP address type
on the switch to
Static
and change the static IP address and subnet
mask to match your network topology. Failure to do so may result in
multiple switches using the same factory default IP address of
192.168.1.254.
