3-15
Cisco ASA 5580 Series Adaptive Security Appliance Hardware Installation Guide
OL-12920-01
Chapter 3 Installing the ASA 5580
Installing the FIPS Enclosure
Figure 14
shows the rear shield assembly of the FIPS enclosure for the ASA 5580.
Figure 14
Rear Shield Assembly
Installing the FIPS Enclosure
This section describes the installation procedure for the front and rear shield assemblies, and includes
the following topics:
•
Installing the Front Shield Assembly, page 3-15
•
Installing the Rear Shield Assembly, page 3-18
Note
The maximum operating temperature for the Cisco ASA 5580 with the shields installed should be 32C.
Installing the Front Shield Assembly
To install the front shield assembly, you must first pull out the processor module from the chassis. To
pull out the processor module, perform the following steps:
Step 1
Power off the ASA.
Step 2
Copy the ASA 5580 serial number on a label and stick it on the chassis where it can be retrieved easily
for future use, if needed. For more information see the
Before You Begin
section.
1
Notched for cables on both sides
2
Screws
279249
2
1