48
Cisco 6100 Thermal Upgrade Kit Installation Procedures
78-10158-01
Installing the Cisco 6100 Thermal Upgrade Kit
Step 3
Install the plastic ESD shield over the system I/O card using the following steps:
a.
Position the holes in the plastic ESD shield over the existing standoff screws installed on the
system I/O card.
b.
Use a Phillips-head screwdriver and the backplane screws you removed in the “Disconnect the
Network Interface Modules” section on page 14 to attach the plastic ESD shield to the system I/O
card (see Figure 31).
Figure 31
Plastic ESD Shield Installation
Tips
For step-by-step instructions on provisioning a Direct Connect configuration, refer to the
ViewRunner for Windows Direct Connect Provisioning Guide or the ViewRunner for HP
OpenView Direct Connect Provisioning Guide.
28926
Standoff
screw
Existing
backplane
screw
ESD
shield
System
I/O card
J2
J1
Existing
standoff
screw
DS3 TX
DS3 RX
P1
P2
P3
P5
SEC
PRI
J7
J2
D25
C25
B25
A25
E25
D1
C1
B1
E1
A1
D25
C25
B25
A25
E25
D1
C1
B1
E1
A1
J1
J4
J3
LAN
Existing
standoff
screw