Cisco 7100 Series, Quick Start Manual

19

Start the System (continued)

7

Configure the Fast Ethernet LAN port in slot 0. Use your own addresses and subnet mask
at the setup prompts. Consult with your network administrator for this information.

Configuring interface parameters:

Do you want to configure FastEthernet0/0 interface? [yes]: yes

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 10.0.0.0

Subnet mask for this interface [255.0.0.0]:

Class A network is 10.0.0.0, 8 subnet bits; mask is /8

Do you want to configure FastEthernet0/1 interface? [yes]: no

Note: Many of the interface LEDs do not go on until you have configured them. To verify
correct operation of each interface, complete the first-time startup procedures and
configuration, and then refer to the LED descriptions in Chaper 1, “Cisco 7100 Series VPN
Router Product Overview” in the Cisco 7100 Series VPN Router Installation and
Configuration Guide to check the status of the interfaces.

8

Configure the ATM port in slot 1. Use your own addresses and subnet mask at the setup
prompts. Consult with your network administrator for this information.

Do you want to configure ATM1/0 interface? [yes]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 10.0.0.10

Subnet mask for this interface [255.0.0.0]:

Class A network is 10.0.0.10, 8 subnet bits; mask is /8

Do you want to configure ATM2/0 interface? [yes]:no

9

Configure the synchronous serial port in slot 4. Use your own addresses and subnet mask
at the setup prompts. Consult with your network administrator for this information.

Do you want to configure Serial4/0 interface 3/0 [yes]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 10.1.1.20

Number of bits in subnet field [0]:

Class A network is 10.1.1.0, 0 subnet bits; mask is /24