R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
3-22
Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0
Chapter 3 Installing a Cisco 7500 Series Router
Installing the Cisco 7513, Cisco 7513-MX, and Cisco 7576
The master RSP will recover from this event and issue a “cBus Complex Restart” message. (Cisco 7513
and Cisco 7513-MX systems that are configured with an RSP4 as the system slave are not affected and
do not experience this problem.) The RSP8 only supports the HSA feature when used with another RSP8.
Note
The Cisco 7576 does not support HSA. The RSP in slot 6 is automatically the system master for router
A and the RSP in slot 7 is automatically the system master for router B.
If you have a Cisco 7513 or Cisco 7513-MX with an RSP2 configured as the system slave, we strongly
recommend that you use the following procedure to remove and replace an interface processor:
Step 1
Remove the slave RSP2 (also called a processor module) using the appropriate procedure in
Figure 3-14
.
Step 2
Wait 15 seconds.
Step 3
Remove and replace the interface processor (also called a processor module) using the procedures in
Figure 3-14
.
Step 4
Wait 15 seconds.
Step 5
Reinsert the slave RSP2 using the appropriate procedure in
Figure 3-14
.
