h = hint used to SIP Alert-INFO rule.
w = waveform-id-or-path which is the index of the desired waveform to use in this ring tone. The built-in
waveforms are:
• 1 = Classic phone with mechanical bell
• 2 = Typical phone ring
• 3 = Classic ring tone
• 4 = Wide-band frequency sweep signal
You can also enter a network path (url) to download a ring tone data file from a server. Add the path in this
format:
w=[tftp://]hostname[:port]/path
c = is the index of the desired cadence to play the given waveform. 8 cadences (1–8) as defined in <Cadence
1> through <Cadence 8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the
natural length of the ring tone file.
b = break-time that specifies the number of seconds to break between two bursts of ring tone, such as b=2.5.
t = total-time that specifies the total number of seconds to play the ring tone before it times out.
Configure the Audio Settings
The user can modify volume settings by pressing the volume control button on the phone, then pressing the
Save
softkey.
Before you begin
Access the phone administration web page. See
Access the Phone Web Page, on page 80
Procedure
Step 1
Select
Voice
>
User
.
Step 2
In the
Audio Volume
section, configure a volume level of 1 (quiet) through 10 (loudest):
•
Ringer Volume
—Sets the ringer volume.
•
Speaker Volume
—Sets the volume for the full-duplex speakerphone.
•
Headset Volume
—Sets the headset volume.
•
Handset Volume
—Sets the handset volume.
Step 3
Click
Submit All Changes
.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
139
Cisco IP Phone Administration
Configure the Audio Settings
