Figure 22: Side View of ADA Non-Lockable Wall Mount Kit Installed on Phone
Install the Non-Lockable Wall Mount Kit for 7861
The wall mount kit can be mounted on most surfaces, including concrete, brick, and similar hard surfaces.
To mount the kit on concrete, brick, or similar hard surfaces, you must provide the appropriate screws and
anchors for your wall surface.
Before you begin
You need these tools to install the bracket:
• #1 and #2 Phillips-head screwdrivers
• Level
• Pencil
You must also install an Ethernet jack for the phone in the desired location if an Ethernet jack does not currently
exist. This jack must be wired appropriately for an Ethernet connection. You cannot use a regular phone jack.
Procedure
Step 1
Mount the wall bracket in the desired location. You can install the bracket over an Ethernet jack, or you can
run the Ethernet network cable to a nearby jack.
If the jack is to be placed behind the phone, the Ethernet jack must be flush to the wall or recessed.
Note
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
109
Hardware and Accessory Installation
Install the Non-Lockable Wall Mount Kit for 7861
