Specify Audio Compliance Standard
You can specify a compliance standard for the audio tuning for the phone. When a compliance standard is
specified, the acoustic parameters that conform to the specified standard are loaded to the phone.
Before you begin
Access the phone administration web page. See
Access the Phone Web Page, on page 80
Procedure
Step 1
Go to
Voice
>
User
.
Step 2
In the
Audio Compliance
section, choose an option from the
Compliant Standard
drop-down list as described
in
.
Step 3
Click
Submit All Changes
.
User Access Control
The Cisco IP Phone respects only the “ua” user access attribute. For a specific parameter, the “ua” attribute
defines access by the user account to the administration web server. If the “ua” attribute is not specified, the
phone applies the factory default user access for the corresponding parameter. This attribute does not affect
access by the admin account.
The value of the element attribute encloses within double quotes.
Note
The “ua” attribute must have one of the following values:
• na – no access
• ro – read-only
• rw – read/write
Phone Web Server
The web server allows administrators and users to log in to the phone by using a phone web user interface.
Administrators and users have different privileges and see different options for the phone based on their role.
Configure the Web Server from the Phone Screen Interface
Use this procedure to enable the phone web user interface from the phone screen.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
140
Cisco IP Phone Administration
Specify Audio Compliance Standard
