Procedure
Step 1
Press
Settings
.
Step 2
Select
Status
.
Step 3
Select
Status Messages
.
Step 4
To remove current status messages, press
Clear
.
Step 5
To exit the Status Messages screen, press
Exit
.
Status Messages
Table 43: Status Messages on the Cisco Unified IP Phone
Possible explanation and action
Description
Message
None. This message is informational only.
The phone obtained its IP address
from a BootP server rather than a
DHCP server.
BootP server used
Cisco Unified Communications Manager
creates a configuration file for the phone
with the phone is added to the database. If
the phone has not been added to the
Cisco Unified Communications Manager
database, the TFTP server generates a CFG
File Not Found response.
•
Phone is not registered with
Cisco Unified Communications
Manager.
You must manually add the phone to
Cisco Unified Communications
Manager if you are not allowing
phones to autoregister. See
Cisco
Unified Communications Manager
Administration Phone Addition, on
page 39
for details.
•
If you are using DHCP, verify that the
DHCP server is pointing to the correct
TFTP server.
•
If you are using static IP addresses,
check configuration of the TFTP
server. See
Network Configuration
Menu, on page 66
for details on
assigning a TFTP server.
The name-based and default
configuration file was not found on
the TFTP Server.
CFG file not found
Cisco Unified IP Phone 7975G, 7971G-GE, 7970G, 7965G, and 7945G Administration Guide for Cisco Unified
Communications Manager 9.0 (SCCP and SIP)
178
Model Information, Status, and Statistics
Status Messages Screen
