4-2
Cisco 819 Integrated Services Router Hardware Installation Guide
OL-23125-02
Chapter 4 Initial Configuration
Cisco IOS CLI
Step 2
Press
Return
. The following message is displayed:
Cisco Configuration Professional Express (Cisco CP Express) is installed on this device.
This feature requires the one-time use of the username "username1"
with the password "password1." The default username and password have a privilege level of
15.
Please change these publicly known initial credentials using Cisco CP Express or the Cisco
IOS CLI.
Here are the Cisco IOS commands.
username <myuser> privilege 15 secret 0 <mypassword>
no username username1
Replace <myuser> and <mypassword> with the username and password you want to use.
For more information about Cisco CP please follow the instructions in the QUICK START
GUIDE for your router...
...
User Access Verification
Username:
Step 3
Enter the username
username1
and press
Return
or
Enter
. The following prompt is displayed:
Password:
Step 4
Enter the password
password1
and press
Return
or
Enter
. The following prompt is displayed:
Router#
A message is displayed that is similar to the first warning message. The message directs you to change
the username and password.
You are now in privileged EXEC mode.
Note
You must change the username and password before you log off the router. You cannot use the
username
username1
or password
password1
after you log off from this session.
Step 5
To change the username and password, enter the following at the prompt:
username
username
privilege 15 secret 0
password
The
username
and
password
are the username and password that you determine.
To continue using the Cisco IOS CLI for initial configuration, see the applicable configuration
procedures in
Cisco 819 Integrated Services Routers Software Configuration Guide
.
Note
Save your configuration changes regularly to avoid losing them during resets, power cycles, or
power outages. Use the
copy running-config startup-config
command at the privileged EXEC
mode prompt (Router#) to save the configuration to NVRAM.
Step 6
Verify the initial configuration. See the
“Verifying the Initial Configuration” section on page 4-5
.
Summary of Contents for 819 series
Page 6: ...Contents 4 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 ...
Page 11: ...9 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
Page 13: ...11 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
Page 18: ...16 Cisco 819 Integrated Services Router Hardware Installation Guide OL 23125 02 Preface ...
