Chapter 2 Installation
Preventing Damage to the Router
2-6
Cisco 831 Router and SOHO 91 Router Hardware Installation Guide
78-14784-02
Step 4
If you plan to use the cable-lock feature, provide a Kensington or equivalent
locking cable.
Preventing Damage to the Router
Follow these guidelines when connecting devices to your router:
•
Connect the color-coded cables supplied by Cisco Systems to the color-coded
ports on the back panel.
•
If you must supply your own cable, see
Appendix A
for cabling
specifications. If this appendix does not provide specifications for a particular
cable, we strongly recommend ordering the cable from Cisco Systems.
Installing the Router
To install the router, you need to perform these tasks in the following order:
1.
Connect the Ethernet devices to the router.
2.
Connect the router to a broadband modem or Ethernet switch.
3.
Connect a terminal or PC to the router (for software configuration using the
command-line interface [CLI] or troubleshooting).
4.
Connect the router to the power source.
5.
Verify the router installation.
6.
Mount the router.
Connecting a Server, PC, or Workstation
Figure 2-1
shows a Cisco 831 router connecting to a PC. (
Figure 2-1
shows a
Cisco 831 router, but it also applies to a SOHO 91 router.) To connect one of these
devices to built-in Ethernet switch port 4, follow the steps given after
Figure 2-1
.
(The connection procedure applies to both the Cisco 831 router and the SOHO 91
router.)
